Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu A Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
186 E300 Design Guide
Issue Number: 1
8 Advanced Parameters
This is a quick reference to all parameters in the drive showing units, ranges limits etc, with block diagrams to illustrate their function and full
descriptions.
Table 8-1 Menu descriptions
* Only displayed when the option modules are installed.
Operation mode abbreviations:
Open-loop:
Sensorless control for induction motors
RFC-A
Asynchronous Rotor Flux Control for induction motors
RFC-S Sensorless: Synchronous Rotor Flux Control for synchronous motors including permanent magnet motors.
Default abbreviations:
Standard default value (50 Hz AC supply frequency)
USA default value (60 Hz AC supply frequency)
In some cases, the function or range of a parameter is affected by the setting of another parameter. The information in the lists relates to the default
condition of any parameters affected in this way.
These advanced parameters are listed for reference purposes only. The lists in this chapter do not include sufficient information for
adjusting these parameters. Incorrect adjustment can affect the safety of the system, and damage the drive and or external equipment.
Before attempting to adjust any of these parameters refer to the full descriptions and to section 7 Commissioning on page 150 and
section 10 Optimization on page 474.
Menu Description
A User menu
B Motor
C Encoder
DBrake
E Mechanical
F Hardware IO
GProfile
H Configuration
I Tuning
J Monitoring
K Logic
L Diagnostics
N Storage
O Backup supply
P Slot 1 Setup*
Q Slot 2 Setup*
R Slot 3 Setup*
S Application Menu 1
T Application Menu 2
U Application Menu 3
V Slot 1 Application*
W Slot 2 Application*
X Slot 3 Application*
Y Data Logger
Z User Menu Setup
AA Slot 4 Setup*
AB Slot 4 Applications*
To Next Page
Loading...
