Safety
information
Product
information
Mechanical
installation
Electrical
installation
Getting
started
User Menu A Commissioning
Advanced
Parameters
Diagnostics Optimization CT MODBUS RTU Technical Data
E300 Design Guide 353
Issue Number: 1
In Open loop:
This is based on the profile position.
This is not available when an analog reference is selected, Control Input Mode (H11) = Analog Run Prmit or Analog 2 Dir (0 or 1).
This indicates measured deceleration distance in mm, which is derived from the position sampled when the decelerating from V1 Speed Reference
(G01) to when the elevator motor stops.
In RFC-A and RFC-S:
This is based on the actual encoder position feedback.
In Open loop:
This is based on the profile position.
This is not available when an analog reference is selected, Control Input mode (H11) = Analog Run Prmit or Analog 2 Dir (0 or 1).
This indicates the sampled elevator speed at the moment floor sensor correction was activated. If the speed at the point when the floor sensor
correction signal was received was too high or the floor sensor correction distance is too short a hard stop may be performed where the profile is
internally modified to prevent position overshoot.
This is based on the profile generator speed.
This indicates the remaining distance to floor level in mm when floor sensor correction is enabled.
Negative values indicate a positional overshoot i.e. it was not possible with the motion profile parameters set and the floor sensor correction distance
to stop without overshooting the required distance.
This is based on the actual encoder position feedback.
This is not available when an analog reference is selected, Control Input Mode (H11) = Analog Run Prmit or Analog 2 Dir (0 or 1).
When set to On (1), this indicates when the elevator speed in mm/s, Actual Speed (J40) is <= Velocity Threshold 1 (H13).
When set to Off (0), this indicates when the elevator speed in mm/s, Actual Speed (J40) is > Velocity Threshold 1 (H13).
This threshold may be used for advanced door opening where Velocity Threshold 1 Status Output (J48) is routed to the lift controller via a digital
J45 Creep Distance Measured
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum 32767
Default Units mm
Type 16 Bit Volatile Update Rate Background
Display Format Standard Decimal Places 0
Coding RO, ND, NC, PT
J46 Speed At Floor Sensor Correction Active
Mode RFC-A, RFC-S
Minimum 0 Maximum 32767
Default Units mm/s
Type 16 Bit Volatile Update Rate Background
Display Format Standard Decimal Places 0
Coding RO, ND, NC, PT
J47 Remaining Floor Sensor Correction Distance
Mode RFC-A, RFC-S
Minimum -32768 Maximum 32767
Default Units mm
Type 16 Bit Volatile Update Rate Background
Display Format Standard Decimal Places 0
Coding RO, ND, NC, PT
J48 Velocity Threshold 1 Status Output
Mode Open-Loop, RFC-A, RFC-S
Minimum 0 Maximum 1
Default Units
Type 1 Bit Volatile Update Rate Background
Display Format Standard Decimal Places 0
Coding RO, ND, NC, PT
To Next Page
Loading...
