NOTE: During idle status, press and quickly release the button, the answering
machine system will announce the time and day setting, or press and quickly
release the button to hear the remote control code. To reset the unit to the
factory default settings, press and hold down the button until you hear a beep
and the LED displays F.
SETTING THE SECURITY CODE
To access this unit from an outside phone you will need to enter a 3 digit code.
The default security code of this unit is (000). To change the security code, press
and hold down the button at idle status. Use the or buttons to adjust, and
the PLAY/STOP button to confirm. Repeat until you have set all three digit. To
check your security code press and quickly release the button.
BASIC OPERATION
BASIC OPERATION
previous
previous
next
Setting Answer On or Off Setting Answer On or Off
The answering system is on by default.
Press the button to turn the answering
system off. Press the button once again
to turn the answering system back on.
use the electronic volume control to set
the sound level. Press the or down
buttons to adjust the volume to the
desired level.
To Next Page
Loading...