O
PERATIONS
13
EN
INITIAL AUTO PRESET
This section describes the initial settings when you
first turn on the power after purchase. The initial
setting items are shown below.
• D.S.T. (Daylight Saving Time)
You can set the air time display for digital broad-
casting. When you set this function to ON, the
date information adjusted for the area set by TIME
ZONE will be adjusted to the one added by anoth-
er 1 hour. In addition, the time difference will be
adjusted as follows: 2 a.m. on first Sunday in April
to 3 a.m., 1 hour ahead, and 2 a.m. on last
Sunday in October to 1 a.m., 1 hour behind.
• TIME ZONE
The EPG information in digital broadcasting is
adjusted based on the area set in TIME ZONE.
• AUTO PRESET CH (DTV/TV)
(When using antenna)
The channels broadcasted in DTV and TV are
automatically scanned and memorized. Only the
receivable channels in the area where this TV is
used will be memorized.
• AUTO PRESET CH (CATV)
(When using basic cable)
The channels broadcasted in CATV are automati-
cally scanned and memorized.
NOTE:
Be sure that antenna or cable is connected properly before
plugging the power cord.
1 Set the D.S.T. (Daylight Saving Time)
When you first turn on the power, the following
screen is displayed.
• Using
[VOL
X
/
Y
] on the remote control, set
"D.S.T. (Daylight Saving)" to [ON] or [OFF].
2
Using [CH
K
/
L
] on the remote control, select
"TIME ZONE".
• Every time you press
[VOL
X
/
Y
] on the remote
control, the area will be switched as below.
• Set your area.
NOTE:
You must set “D.S.T.” and “TIME ZONE” before presetting
channels.
To Next Page
Loading...
