Emerson EWFG2705 - Sleep Timer

26
EN
4 Display the "CHANGE CODE" screen.
• Using
[CH
K
/
L
] on the remote control, select
"CHANGE CODE".
• Press
[VOL
X
] on the remote control.
5
Change the access code.
• Use
Channel number buttons on the remote
control and enter the NEW 4-digit CODE.
• Enter code again in CONFIRM CODE box.
6
To exit the menu, press [MENU] on the remote
control.
NOTES:
• Make sure to enter the exact same new code in the "CON-
FIRM CODE" space as one in the "NEW CODE" space. If
they are different, the "NEW CODE" space is cleared for
reentering.
• Your personal access code will be erased and return to the
default (0000) when a power failure occurs or when you turn
off the power using a wall switch. If you forget the code,
unplug the power cord for 10 seconds to restore the access
code to 0000.
NEW CODE
_ _ _ _
CONFIRM CODE
_ _ _ _
TV RATING
MPAA RATING
CHANGE CODE
C
CHANGE CODE
SLEEP TIMER
The SLEEP TIMER function will automatically turn
off the power of the unit at a preset time.
1
Use SLEEP TIMER.
• Press
[SLEEP] on the remote control.
• The setting display for SLEEP TIMER is shown
in the screen.
2 Set the timer.
• Every time you press
[SLEEP] on the remote
control, the time increases by 10 minutes.
• You can set the timer up to 90 minutes.
• After setting, you can check the remained time
per 1 minute by pressing
[SLEEP].
NOTES:
• When you disconnect the unit from the AC outlet or when a
power failure occures, the sleep timer setting will be can-
celed.
• To cancel the sleep timer, press
[SLEEP] on the remote
control repeatedly until "SLEEP 0" is displayed.
• The Sleep Timer setting display will automatically disappear
after 10 seconds.
SLEEP 16
SLEEP 0
CH
CH
VOL VOL
CHANNEL
RETURN
–
/ENT
INPUT
SELECT
321
654
98
+
100
0
7
MUTE
SLEEP
MENU
SLEEP