To Next Page

To Previous Page

5-2 L6406EA

2. Black Stretch Control Adjustment

Purpose: To show the fine black color.

Symptom of Misadjustment: Black color will not

appear correctly.

Note: Use service remote control unit.

1. Enter the Service mode. (See page 5-1)

2. Press "6" button on the service remote control unit.

"B-S" is indicated.

3. Press "CH o / p" buttons on the service remote con-

trol unit so that display will change "OFF," "0," "1," "2"

and "3." Then choose "B-S OFF."

4. Press "6" button on the service remote control unit.

"B-S*2" is indicated.

5. Press "CH o / p" buttons on the service remote

control unit so that display will change "0" and "1."

Then choose "B-S*2 0."

6. Turn the power off and on again, using the main

power button on the TV unit.

3-1. Setting for Data Values

General

1. Enter the Service mode. (See page 5-1)

2. To select the Data Value, press "VOL p" button on

the service remote control unit.

3. To set the following each data value, press "CH o

/ p" buttons on the service remote control unit.

7F --- set to 7F

FRENCH --- set to OFF

ACCESS CODE --- set to OFF

STEREO --- set to ON

VIDEO TONE --- set to OFF

FM-MODE --- set to OFF

V-OUT --- set to OFF

3-2. Setting for CONTRAST,

COLOR, TINT, V-TINT and

SHARP data Values

General

1. Enter the Service mode. (See page 5-1)

2. Press "MENU" button on the service remote control

unit. Display changes "BRIGHT," "CONTRAST,"

"COLOR," "TINT," "V-TINT" and "SHARP" cyclically

when "MENU" button is pressed.

CONTRAST (CNT)

1. Press "MENU" button on the service remote control

unit. Then select "CONTRAST" (CNT) display.