June 2022
Installation, Operation and Maintenance Manual
VCIOM-01494-EN Rev. 0
4
Installation
Section 2: Installation
2.1 Assembling Procedure for Models 63-125 Nm
Old Version (US or Non US Market)
• Detect the 4 black cables required for the OM1 which are already included in the
basic actuator as shown in Figure 3.
• Connect the at cable furnished into the kit to connector J9 on OM1 as shown in
Figure 4.
Figure 3
Figure 4
• Unscrew the 3 screws as shown in Figure 5:
— 3 pcs M3x10
• Tighten the 3 metal spacers as shown in Figure 6.
To Next Page
Loading...
