6
Supplied Accessories
Owner's Manual Quick Start Guide Registration card
Remote Control
(NHO01UD)
Batteries
(AAA, 1.SV x 2)
TV base and 6 screws (MS x 12)
AC power cord
If you lose the scrcws, please purchase MS x I 2 Ph IIps head screws
at your Iota store,
If you need to rep ace these accessores, please refer to the part
No, wth the ustrations and call our to free customer support
Ine found on the cover of this manua,
Vhm csrlZ _ unversa e so/;e con _'h to (pel_te ths un
Make sure the component code on your universa i_mote control
is set to our brand, Refer to the manual accompanying your
remote contl_l for more detaiB,
We do not guarantee 100% interopel abilty with all universal
romote contro s,
Symbols Used in this Manual
The following s the descr ption for the symbols used n ths
manual, Description refers to:
:D gital]V operat on
:Analog / Cable ]V operation
If nether symbol appears, the operation s applicable to
both.
Attaching the Base
You must attach the base to the unt to have t as a table top
unit. Be sure the front and real" of the base match the proper
direction.At leas? 2_people are requ red for these steps.
1 Check the text "FRONT" with "an'ow" on the Base's
bottom to ensure t is beng inslalled n the correct
direction. Spread a thick and soft cloth over a table as shown
at step 2. Place the main unit face down onto t Make sure
not to damage the screen.
2 Insert 2 hooks under the
bottom of the main unt @
into base holes. (shown by _.
an'ow 11)),then move the
base n the d rect on as
shown by an'ow {2} until t
stops and the screw holes
are aligned.
Drve Ph ilips head screws
into the 6 threaded holes
atthe bottom of the base
until they are tight.
Io _ , hove the base from ths ult
• Unscrew the Phillips head screws in step 3,
After the screws is removed, move the base in the opposite
d rection as shown by an ow in step 2, then pul the base up toward
the real of the unt Be cal_ful not to drop the base when you
remove it
Note
When attaching the base, ensure that a screws are tightly fastened,
Iftl_e base is not propel 17attached, it could cause the unt to fJII,
result ng n njuries as well as damste to the unt,
Mal<e sure to use a tabe wl_ch can support the weight ofths unt
and s arger titan this unt
blal<o sum the table s in stable !ocation,
When attaching the base, ensure that"FRONT" wth "an-ow"
written on the bottom of the base is downward. If t's not
downward, the _ hooks don't fit into the base,
Mounting the Unit onYour Furniture
Screw this unt on your furnture t ghtly usng wood screws
(not supplied) in the 2 holes at the back of the base as shown.
• Recommended sclsw dimens on :3/16 x 3/4 nches(5,1 x Z0 ram)
rear of this unit
screw holes
To Next Page
Loading...
