Chapter 3 Web Page Of RDU-SIC G2 13
RDU-SIC G2 Card User Manual
3.4.1 Device Information
Click the Device Info menu in the left, the submenus will appear. When you click the specific device, the right part will
display the relative information of the device, including Sampling, Control, Setting and Alarm.
Note
ENV in Device Info is a dummy device, which indicates all temperature sensors and temperature & humidity sensors connected
to RDU-SIC G2.
Sampling
Clicking the Sampling tab can enter the sampling page, which displays sampling signals of selected device, as shown
in Figure 3-15.
Figure 3-15 Sampling signals
If some signal is in alarm status, it will be displayed in red.
Control
Clicking the Control tab can enter the control page, which displays control signals of selected device, as shown in
Figure 3-16.
Figure 3-16 Control signals
Click the Set button to control the device.
Setting
Clicking the Setting tab can enter the setting page, which displays setting signals of selected device, as shown in
Figure 3-17.
Figure 3-17 Setting signals
To Next Page
Loading...
