Emerson Mentor MP - Status Indications; Trip Masking

Mentor MP Short Form Guide 127
Issue Number: 5 www.controltechniques.com
Safety Information Product information
Mechanical
installation
Electrical
installation
Getting started Running the motor
SMARTCARD
operation
Advanced
parameters
Diagnostics
UL listing
9.3 Status indications
Table 9-3 Status indications
9.4 Trip masking
Drive trips can be masked by setting the appropriate trip code in Pr 10.52 to Pr 10.61.
Refer to Pr 10.52 to Pr 10.72 (Advanced parameter descriptions chapter - Menu 10) in
the Mentor MP Advanced User Guide for further information.
Upper display Description Drive output stage
dEC Decelerating
Enabled
Speed is ramping to zero after a stop
inh
Inhibited
Disabled
Enable input is inactive
POS Position
Enabled
Position control active during orientation stop
rdY Ready
Disabled
Enable closed, but drive not active
run
Running
Enabled
Drive active and motor running
StoP Stopped
Enabled
Drive active, but holding zero speed.
triP Tripped
Disabled
Drive is tripped.