Figure 5-2: Connecting the PoE on Channel A of the Transmitter
3. Because the Cat5e and higher-rated Ethernet cables are 360° bonded these cables
need to be grounded at the host end.
4. Replace the display where applicable, and the housing cover.
5.3 Wire the power supply using an M12-
terminated cable (optional)
Use this procedure if you are using an M12-terminated cable to wire the power supply.
Prerequisites
Obtain an A-coded M12-terminated cable.
Procedure
1. Attach the M12-terminated cable to the power connector on the 1600 transmitter.
Installation Manual Power supply wiring
00825-0100-1600 March 2022
Installation Manual 27
To Next Page
Loading...
