8. Perform a test print to verify the settings are correct.
Display Menu → Operations → Printer → Print Ticket → Print Test
Page
ProLink III Device Tools → Configuration → Printer and Tickets
Web browser Configuration → Printer and Tickets
For instructions on how to configure print ticket options, see the Micro Motion 1600
with Ethernet Transmitters: Configuration and Use Manual.
If needed, see Function Check Failed in the Status alerts, causes, and recommendations
section of the Micro Motion 1600 with Ethernet Transmitters: Configuration and Use Manual.
6.2 Set up the printer using the printer default IP
address
Use this procedure to set up printing with a 1600 Ethernet transmitter and an Epson TM-
T88VI printer using the printer's default IP address.
Procedure
1. Connect one end of an Ethernet cable and power supply to the printer.
2. Connect the other end of the Ethernet cable to the PC.
3. Power on the printer.
It can take 1-2 minutes for the printer to finish configuring network settings. When
complete, the following ticket prints.
*********************************
IP Address : 192.168.192.168
SubnetMask : 255.255.255.0
Gateway : 0.0.0.0 DHCP : No server - > Static
*********************************
4. Turn off DHCP if it is enabled.
From the display
From ProLink III
a. Go to Menu → Configuration →
Ethernet Settings → Network Settings
→ Auto obtain IP()DHCP.
b. Select Disabled and Save.
c. Back out to the Ethernet Settings page
to apply the DHCP off setting.
a. Go to Device Tools → Configuration →
Network Settings.
b. Uncheck Obtain an IP address
automatically (DHCP).
c. Select Apply.
Installation Manual Set up the printer
00825-0100-1600 March 2022
Installation Manual 31
To Next Page
Loading...
