Emerson Micro Motion 1600 - Page 132

3. Begin the batch.
Option Description
Display Choose Menu → Batcher → Run Batch → Batch Control and select Begin.
ProLink III Choose Device Tools → Application Control → Batching → Run Batcher and
select Begin Batch.
Field communicator Not available
The transmitter automatically resets the batch total to 0 if you have selected Reset on Start. Otherwise,
you must manually reset the batch total before the batch will start.
4. Monitor the batch during processing.
Option
Description
Display Choose Menu → Batcher → Run Batch and observe the value displayed in Batch
Total.
ProLink III Choose Device Tools → Application Control → Batching → Run Batcher and
observe the values displayed in Current Total and Batch Time.
Field communicator Not available
5. Optional: Pause the batch at any time.
Option
Description
Display Choose Menu → Batcher → Run Batch → Batch Control and select Pause.
ProLink III Choose Device Tools → Application Control → Batching → Run Batcher and
select Pause Batch.
Field communicator Not available
Pausing a batch allows you to resume it later.
6. Optional: Resume the batch after it has been paused.
Option
Description
Display Choose Menu → Batcher → Run Batch → Batch Control and select Resume.
ProLink III Choose Device Tools → Application Control → Batching → Run Batcher and
select Resume Batch.
Field communicator Not available
Operation using the batcher Configuration and Use Manual
May2024 MS-00809-0200-1600
132 Emerson.com