Components of a 4-wire remote mount transmitter (stainless steel
housing)
Figure 3-4:
A. Transmitter
B. Mounting bracket
C. Cap screws
D. End-cap
2. Attach the mounting bracket to an instrument pole.
3.2 Prepare the 4-wire cable
Important
For user-supplied cable glands, the gland must be capable of terminating the drain wires.
Note
If you are installing unshielded cable in continuous metallic conduit with 360º termination shielding,
you only need to prepare the cable – you do not need to perform the shielding procedure.
Mounting and sensor wiring for 4-wire remote installations
20 Micro Motion
®
Model 1700 and 2700
To Next Page
Loading...
