1 Before you begin
1.1 About this manual
This manual helps you configure, commission, use, maintain, and troubleshoot Micro Motion 4200
transmitters.
Important
This manual assumes that the following conditions apply:
• The transmitter has been installed correctly and completely according to the instructions in the
transmitter installation manual
• The installation complies with all applicable safety requirements
• The user is trained in government and corporate safety standards
1.2 Related documents
See the approval documentation shipped with the transmitter, or download the appropriate documentation
from the Micro Motion web site (www.emerson.com):
• Micro Motion 4200 2-Wire Transmitter: Installation Manual
• Micro Motion 4200 2-Wire Transmitter: Product Data Sheet
• Micro Motion 4200 2-Wire Transmitter: Safety Manual for Safety Instrumented Systems
• Micro Motion ProLink III User Manual
• Sensor installation manual, which is shipped with the sensor
• FMEDA report for Coriolis Flowmeter with the 4200 Transmitter, Prepared for Emerson by exida.com LLC
1.3 Installation types
The 4200 transmitter was ordered and shipped for one of two installation types. The fifth character of the
transmitter number indicates the installation type.
Figure 1-1: Installation type indication for 4200 transmitters
The number is located on the device tag on the side of the transmitter.
Table 1-1: Installation types for 4200 transmitters
Code Description
I Integral mount
C Remote mount
Configuration and Use Manual Before you begin
MMI-20048166 April 2019
Configuration and Use Manual 7
To Next Page
Loading...
