2. Gently lift the transmitter on the feed through until it disengages from the notches
on the feed through. You will not be able to remove the transmitter completely.
3. Rotate the transmitter to the desired position.
CAUTION
Do not rotate the housing more than 360°. Excessive rotation can damage the
wiring and cause measurement error or flowmeter failure.
4. Lower the transmitter, sliding it onto the notches on the feed through.
5. Replace the clamping ring on the feed through. Tighten the screw to 28 in lbf
(3.16 N m)– 32 in lbf (3.62 N m).
CAUTION
Ensure that the connection between the transmitter and the sensor is moisture-
proof. Inspect and grease all gaskets and O-rings. Moisture in the electronics can
cause measurement error or flowmeter failure.
2.6 Rotating the display orientation
The user interface orientation for the 4200 transmitter can rotate 360° in 90° increments
by software selection.
Using the display, select Menu > Configuration > Display Settings > Rotation.
Mounting and sensor wiring Installation Manual
April 2019 MMI-20058013
18 Micro Motion
®
4200 2-Wire Transmitter
To Next Page
Loading...
