Emerson Micro Motion 5700 - Configure Discrete Output Polarity

Option Label State DO voltage
Display PLIII FC Web browser
Batch Primary
Valve
Batch Primary
Valve
Batch Primary
Valve
Primary Valve Batch Primary
Valve
ON • Internally powered:
24 VDC
• Externally powered: Site-
specific
OFF 0 V
Batch
Secondary
Valve
Batch
Secondary
Valve
Batch
Secondary
Valve
Secondary
Valve
Not applicable ON • Internally powered:
24 VDC
• Externally powered: Site-
specific
OFF 0 V
Batch Pump Batch Pump Batch Pump Batch Pump Not applicable ON • Internally powered:
24 VDC
• Externally powered: Site-
specific
OFF 0 V
(1) Events configured using the enhanced event model.
(2) Events configured using the basic event model.
Important
This table assumes that Discrete Output Polarity is set to Active High. If Discrete Output Polarity is set to
Active Low, reverse the voltage values.
Important
Actual flow direction interacts with Sensor Flow Direction Arrow to determine the flow direction that the
transmitter uses in processing. See the following table.
Table 8-3: Interaction between actual flow direction and Sensor Flow Direction Arrow
Actual flow direction Setting of Sensor Flow Direction
Arrow
Flow direction sent to outputs and
totalizers
Forward (same direction as Flow arrow
on sensor)
With Arrow Forward
Against Arrow Reverse
Reverse (opposite from Flow arrow on
sensor)
With Arrow Reverse
Against Arrow Forward
Related information
Configure Sensor Flow Direction Arrow
8.6.2 Configure Discrete Output Polarity
Display
Menu > Configuration > Inputs/Outputs > Channel x > I/O Settings > Polarity
Integrate the meter with the control system Configuration and Use Manual
March 2019 MMI-20025166
160 Micro Motion Model 5700 Transmitters with Configurable Outputs