Emerson Micro Motion 5700 - Perform a D1 and D2 Density Calibration Using the Field Communicator

Postrequisites
If you disabled LD Optimization before the calibration procedure, re-enable it.
14.6.3 Perform a D1 and D2 density calibration using the Field
Communicator
Procedure
1. Read the Prerequisites in Perform a (standard) D1 and D2 density calibration if you have not already
done so.
2. See the following figure.
Measurement support Configuration and Use Manual
March 2019 MMI-20025166
220 Micro Motion Model 5700 Transmitters with Configurable Outputs