Emerson Micro Motion 5700 - Wire the Frequency Output (Externally Powered Channel D)

4.6.2 Wire the Discrete Output (externally powered)
Use this procedure to wire the externally-powered Discrete Output for Channel B or C.
Procedure
Wire to the appropriate output terminal and pins.
Figure 4-18: Discrete Output wiring (externally powered)
A
B
E
D
C
A. Discrete Output
B. Channel B or C
C. 3–30 VDC (maximum)
D. 500 mA current (maximum)
E. Counter
4.6.3
Wire the Discrete Output (internally powered Channel
D)
Procedure
Wire to the appropriate output terminal and pins.
Figure 4-19: Discrete Output wiring (internally powered)
A
7
8
C
B
A. Discrete Output
B. See Figure 4-20 for output amplitude versus load resistance
C. Counter
Installation Manual Wiring the channels
MMI-20027478 February 2020
Installation Manual 33