2 Installation
2.1 Unpacking and inspection
Carefully remove all of the components from the packaging and verify them against the
enclosed packing list. Inspect all components for any obvious damage such as broken or
loose parts. If you find any components missing or damaged, notify your local Net Safety
representative or the factory immediately. Figure 2-1 outlines the components supplied
with the APM.
APM componentsFigure 2-1:
2.2 Locate sensor
Prior to the installation process, a location plan for placing the APM sensor and transmitter
should be developed. Proper location of the APM sensor is essential for providing
maximum protection. The most effective placement and number of detectors varies
depending upon conditions. The following points should be considered when planning the
installation.
• Carefully locate the APM sensor in an area where particulate may potentially
accumulate.
• The APM sensor should be located where it is safe from potential sources of
contamination such as oil film, dirt, etc.
Installation
3
To Next Page
Loading...
