Emerson Net Safety Millennium - Non-Isolated and Isolated Power Configurations

Jumper locationsFigure 2-14:
2.7 Non-isolated and isolated power
configurations
For current source using Non-Isolated configuration, the jumper must remain in the
default position (Pin 2 and Pin 3 jumped). The jumper is placed over Pin1 and Pin 2 for
current sink using Non-Isolated configuration.
For Isolated configuration using a separate power supply to isolate the current loop, the
jumper must be placed over Pin 1 and Pin 2 for source and sink. Refer to Figure 2-15.
Note the Jumper position for each configuration.
Installation
19