10
14. Position the center styrofoam section on the
upper section, and then position the fan motor
and housing on the center section so that the bot-
tom of the motor is facing you (Figure 24). The
styrofoam sections will hold the assembly while
you perform the following steps.
15. Position the flatwasher (supplied in parts bag) on
the motor shaft (Figure 24).
16. Using the 3/16” setscrew wrench (supplied),
loosen the setscrew in the collar, then screw the
light kit adapter assembly onto the motor shaft
(Figure 25). Tighten the setscrew to secure the
adapter assembly to the shaft. Securely engage
the connector from the reversing switch to the
connector from the motor shaft.
17. Securely connect the black wire from the light kit
plate assembly to the blue wire from the motor
shaft using a wire connector (supplied)
(Figure 26). Connect the white wire from the plate
assembly to the white wire from the motor shaft
using a wire connector (supplied).
18. Secure the light kit plate assembly to the light kit
adapter assembly by threading three 8-32 x 3/8”
phillips head screws (supplied) into the threaded
holes in the adapter assembly. (Figure 27).
NOTE: Do not pinch wires between the light kit
plate assembly and the adapter assembly.
19. Lift the fan assembly from the styrofoam and
remove the center styrofoam section. Turn the fan
assembly over and carefully position it on the
upper styrofoam section so that the hanger
ball/downrod assembly is at the top (Figure 28).
20. Position one fan blade on the flange assembly and
secure by installing the left and right blade holder
caps using two 10-32 x 3/8” pan head screws (sup-
plied) for each holder cap (Figure 29). Install the
remaining four fan blades using the same procedure.
To Next Page
Loading...
