Emerson ODYSSEY CF2455BS00 - Page 10

5. Obtain the die cast glass holders and light kit glass
from the protective bags.
6. Position the light kit glass carefully on a convenient
surface with the open side face down.
7. Remove the protective cover from the adhesive
backed material on the glass holders (Figure 18).
8. Firmly press the die cast glass holders into
position on the light kit glass (Figure 19).
9. Repeat these procedures for the second die cast
holder.
10. Carefully turn the light kit glass assembly over.
Thread two knurled knob screws (supplied)
several turns onto the die cast glass holders
(Figure 20). Leave approximately 3/16” of the
stud threads revealed.
10
LIGHT KIT ADAPTER
LIGHT KIT GLASS
KNURLED KNOB
SCREW
ROTATE LIGHT KIT GLASS
COUNTERCLOCKWISE
VIEWED FROM TOP
Figure 21
12. Your ceiling fan is now installed and wired and
ready for use.
DIE CAST
GLASS HOLDER
PROTECTIVE COVER ON
ADHESIVE BACKED MATERIAL
Figure 18
DIE CAST
GLASS HOLDER
LIGHT KIT
GLASS
Figure 19
TURN KNURLED KNOB
SCREW SEVERAL TURNS
INTO THE GLASS HOLDER
LIGHT KIT
GLASS
DIE-CAST GLASS
HOLDER
Figure 20
11. Raise the light kit glass assembly and insert the
two knurled knobs through the two keyholes in
the light kit adapter. Turn the light kit glass
assembly counterclockwise to engage the
knurled knob screws in the slots (Figure 21).
Carefully reach between the fan blade flanges
and the light kit glass and securely tighten the
two knurled knob screws.