Rosemount Model 1195/ProPlate/Mass ProPlate
6-32
NOTE
Since the Compensated Flow procedure automatically includes these
settings as the units for either a configuration file, or as the units sent
to the transmitter during a send configuration operation, be sure that
this screen is set correctly before performing the Compensated Flow
procedure.
Setup Damping
This screen sets the damping for four process variables: Differential
Pressure, Absolute Pressure, Gage Pressure, and Process Temperature.
NOTE
Since the Compensated Flow procedure automatically includes these
settings as the damping parameters for either a configuration file, or as
the damping values sent to the transmitter, be sure that this screen is
set correctly before performing the Compensated Flow procedure.
Figure 6-27.
Units Screen.
Figure 6-28.
Damping Screen.
To Next Page
Loading...
