Reference Manual
00809-0100-4690, Rev FC
June 2011
Rosemount 2088 and 2090
3-4
CONFIGURATION DATA
REVIEW
NOTE
Information and procedures in this section that make use of Field
Communicator fast key sequences and AMS Device Manager assume that
the transmitter and communication equipment are connected, powered, and
operating correctly.
The following is a list of factory default configurations. These can be reviewed
by using the Field Communicator or AMS Device Manager
Field Communicator
Enter the fast key sequence to view the configuration data.
AMS Device Manager
Right click on the device and select “Configuration Properties” from the menu.
Select the tabs to review the transmitter configuration data.
4-20 mA Fast Keys
1, 5
Tag Range
Date Descriptor
Message Minimum and Maximum Sensor Limits
Minimum Span Units
4 and 20 mA points Output (linear or sq. root)
Damping Alarm Setting (high, low)
Security Setting (on, off) Local Zero/Span Keys (enabled,
disabled)
Integral Display Sensor Fill
Isolator Material Flange (type, material)
O-Ring Material Drain/Vent
Remote Seal (type, fill fluid, isolator material,
number)
Transmitter S/N
Address Sensor S/N
To Next Page
Loading...
