Figure 5-4: LOI Menu
5.3 Switch HART Revision mode
Task steps to switch the HART Revision mode from the generic menu.
If the HART configuration tool is not capable of communicating with HART
Revision 7, the Rosemount 2088, 2090F, or 2090P will load a generic menu
with limited capability. The following procedures will switch the HART
revision mode from the generic menu:
Procedure
Go to Manual Setup → Device Information → Identification → Message
a) To change to HART Revision 5, Enter: “HART5” in the Message field.
b) To change to HART Revision 7, Enter: “HART7” in the Message field.
March 2022 Quick Start Guide
Quick Start Guide 19
To Next Page
Loading...
