3 Installation
3.1 Safety messages
Instructions and procedures in this section may require special precautions to ensure the
safety of the personnel performing the operations. Information that potentially raises
safety issues is indicated by a warning symbol ( ). Refer to the following safety messages
before performing an operation preceded by this symbol.
WARNING
Failure to follow safe installation and servicing guidelines could result in death or serious
injury.
• Ensure only qualified personnel perform the installation.
• Use the equipment only as specified in this manual. Failure to do so may impair the
protection provided by the equipment.
• Do not perform any services other than those contained in this manual unless you are
qualified.
Explosions could result in death or serious injury.
• Verify that the operating environment of the device is consistent with the appropriate
hazardous locations certifications.
• Before connecting a handheld communicator in an explosive atmosphere, ensure that
the instruments in the loop are installed in accordance with intrinsically safe or non-
incendive field wiring practices.
• Do not remove the gauge cover in explosive atmospheres when the circuit is alive.
• To prevent ignition of flammable or combustible atmospheres, disconnect power
before servicing.
High voltage that may be present on leads could cause electrical shock.
• Avoid contact with leads and terminals.
• Ensure the main power to the Rosemount 2410 Tank Hub is off and the lines to any
other external power source are disconnected or not powered while wiring the gauge.
Reference Manual Installation
00809-0100-2410 December 2019
Rosemount 2410 Tank Hub 25
To Next Page
Loading...
