130
Reference Manual
00809-0100-2460, Rev DE
Service and Troubleshooting
October 2018
Service and Troubleshooting
6.16 Restore to factory defaults
You may erase the current configuration and reset the Rosemount
™
2460 System Hub to factory
defaults.
To reset the Rosemount 2460 to factory defaults:
1. Open the system hub’s Web interface. See “Using the web interface” on page 114.
2. Select the Configuration > Configuration Data Base (CDB) option.
3. Click the Restore button.
4. A dialog appears which prompts you to confirm the restore command.
5. Click Cancel in case you want to interrupt, or Yes to proceed with resetting the current configuration
to the factory default configuration.
Note
Restoring the system hub to factory default can not be reversed. It is recommended to save the
configuration database (CDB) in case you would like to return to the current configuration (see
“Configuration backup” on page 131).
Note
Communication settings, except Modbus address and communication settings for Eth1, are restored to
factory settings.
To Next Page
Loading...
