Review installation considerations.
See “Installation considerations” on page 23.
Mount the Rosemount 2460 System Hub.
See “Mechanical installation” on page 25.
Wire the Rosemount 2460.
See “Electrical installation” on page 28.
Make sure covers and cable gland/conduit
connections are tight.
Power up the Rosemount 2460.
Configure the Rosemount 2460.
See Section 4: Configuration:
- Enable communication with host system
- Configure ports
- Configure Tank Database
Verify operation.
Enable the Write Protection switch if required.
If needed, install modem cards to support the
desired communication protocols.
See “Exchanging a modem card” on page 108
To Next Page
Loading...
