4
Reference Manual
00809-0100-4021, Rev JA
Introduction
April 2017
Introduction
Rev 3 3.10.23 7 1.3.1 1.0.0
Device Compliance to ITK 6.0.1. Addition of
NE107 device diagnostic information. Ease of use
improvements including:
Hot Backup functionality has been moved to
the transducer block, allowing easier
configuration from the DD
Device is shipped with the simulate switch
ON, allowing device alerts simulation without
cover removal
Device has unique block names using the last
four digits (XXXX) of the output board serial
number, e.g. AI_1400_XXXX
All blocks are instantiated before shipping,
including model option code dependent
blocks. The product also has all parameters
initialized so that its primary measurement is
available with no user changes required.
All devices ship will AI block scheduled.
Customer will be able to use old DD files when
replacing a device with a newer rev device -
This is possible for devices with device
revision number 3 and above.
Wherever possible, the product ships with
parameters initialized to common values. The
product shall ship with no uninitialized
parameters that will keep the transmitter
from providing its primary measurement
right out of the box.
The product's default block tags are be less
than or equal to 16 characters in length.
Custom function blocks were replaced with
enhanced function blocks.
Default block tags include underscores, “_”,
instead of white spaces.
The CF file has a better description of the
device, including meaningful defaults and
example values.
Device provides means to properly range
graphs and charts in the device dashboards.
June 2013
Table 1-2. FOUNDATION Fieldbus Revisions
Device
revision
Software
revision
Hardware
revision
NAMUR
software
revision
NAMUR
hardware
revision
Description Date
To Next Page
Loading...
