3. Remove the plastic plugs.
4. Pull the cable through the cable gland/conduit.
Adapters are required if M20 glands are used.
5. Connect the cable wires (see Figure 4-7, Figure 4-15, and Figure 4-9).
6. Ensure proper grounding (see Grounding).
7. Use the enclosed metal plug to seal any unused port.
Note
Apply PTFE tape or other sealant to the threads.
Electrical installation Reference Manual
April 2019 00809-0100-4530
108 Rosemount 5300 Level Transmitter
To Next Page
Loading...
