8. Select the desired transmitter and select OK to connect.
9. In the RRM Status Bar, verify that RRM communicates with the transmitter.
A. RRM communicates with the transmitter
B. No communication with the transmitter
5.5.7
Specifying measurement units
Measurement units for data presentation in RRM can be specified when the RRM program
is installed. Units can also be changed as follows:
Procedure
1. Select View → Application Preferences.
2. Select the Measurement Units tab.
3. Choose the desired units for length, level rate, volume, and temperature.
5.5.8
Using the setup functions
Use the setup function if you are already familiar with the configuration process for the
Rosemount 5300 Series Transmitter or for changes to the current settings:
Procedure
1. Start the RRM software.
2. In the RRM workspace choose the appropriate icon for the configuration of
transmitter parameters:
Reference Manual Configuration
00809-0100-4530 April 2019
Reference Manual 127
To Next Page
Loading...
