Emerson Rosemount 5300 Series - Page 163

6.3.2 Specify display panel variables using AMS Device
Manager
Specify variables and corresponding measurement units to be presented on the display
panel (LCD) screen:
Procedure
1. HART
®
: Select Configure → Manual Setup → Device Setup.
FOUNDATION
™
Fieldbus: Select Configure → Manual Setup
2. Select the Display tab.
3. Select the desired variables and measurement units to be displayed on the LCD
display.
4. Select Send to save the configuration and close the window.
6.3.3
Specify display panel variables using a handheld
communicator
Specify variables and corresponding measurement units to be presented on the display
panel (LCD) screen:
Procedure
1. Specify LCD parameters:
a) HART
®
: Select Configure → Manual Setup → Device Setup.
FOUNDATION
™
Fieldbus: Select Configure → Manual Setup
b) Select Display.
c) Select LCD Parameters.
d) Select the desired variables to be displayed on the LCD display.
Reference Manual
Operation
00809-0100-4530 April 2019
Reference Manual 163