e) Select Send, and follow the instructions.
2. Specify measurment units:
a) HART: Select Configure → Manual Setup → Device Setup.
FOUNDATION Fieldbus: Select Configure → Manual Setup.
b) HART: Select Units.
FOUNDATION Fieldbus: Select LCD Units.
c) Specify desired measurement units.
d) Select Send, and follow the instructions.
6.3.4 Specify display panel variables using DeltaV
To specify which variables to view on the display panel (LCD) screen and the
corresponding measurement units:
Procedure
1. Right-click the transmitter icon and choose the Properties option.
2. Select the Transducer1100 block.
3. Select the LCD tab.
4. Select the variables to be shown on the display panel.
5. Select the desired LCD measurement units.
You can specify the same measurement units as selected in the Product Values tab
and in the Interface Values tab by choosing the Auto option for the LCD Unit.
6. Select OK to save the LCD settings in the transmitter database.
Operation
Reference Manual
April 2019 00809-0100-4530
164 Rosemount 5300 Level Transmitter
To Next Page
Loading...
