Emerson Rosemount 5300 Series - Page 217

Figure 7-25: The Reset to Factory Settings Window in Rosemount Radar Master
Reset to factory settings using AMS Device Manager
This function resets all or a specific part of the holding registers to factory settings.
Prerequisites
Note
It is recommended that a backup of the configuration is done before the factory reset.
Then the old transmitter configuration can be loaded if necessary.
Procedure
1. Select option Service Tools → Maintenance → Reset/Restore.
2. HART: Select the Restore Default Settings button and follow the instructions.
FOUNDATION Fieldbus: Select the Reset to Factory Default button and follow the
instructions.
Reset to factory settings using DeltaV
This function resets all or a specific part of the holding registers to factory settings.
Prerequisites
Note
It is recommended that a backup of the configuration is done before the factory reset.
Then the old transmitter configuration can be loaded if necessary.
Procedure
1. In the DeltaV
™
Explorer, select the desired transmitter icon, and then right-click the
TRANSDUCER1100 block icon.
2. Select Factory Settings.
Reference Manual Service and troubleshooting
00809-0100-4530 April 2019
Reference Manual 217