Table F-2: Level Transducer Block Parameters and Descriptions (continued)
Parameter Index Number Description
UPPER_PRODUCT_DC 43 Enter the Upper Product Dielectric Constant (DC) as
dielectric accurate as possible. This value affects the
accuracy of the interface level measurement
LOWER_PRODUCT_DC_RANGE 44 Enter the range of the dielectric constant (DC) for the
lower product in the tank. If you are uncertain about
the value for this parameter or are changing product in
the tank on a regular basis choose Unknown
PRODUCT_DIELEC_RANGE 45 Enter the range of the Product DC for the product in
the tank. If you are uncertain about the value for this
parameter or are changing product in the tank on a
regular basis choose Unknown
MEAS_MODE 46 Select the Measurement Mode to use in the device.
Some modes require software options to be enabled in
the device. You can upgrade the device to enable more
software options
DAMP_VALUE 47 Damping value
GEOM_OFFSET_DIST 48 Distance Offset
GEOM_CALIBRATION_DIST 49 Calibration Distance
LCD_SETTINGS 50
LCD_PARAMETERS 51 Parameters to show
LCD_LANGUAGE 52 Language on display
LCD_LENGTH_UNIT 53 Length unit on display
LCD_VOLUME_UNIT 54 Volume unit on display
LCD_TEMPERATURE_UNIT 55 Temperature unit on display
LCD_VELOCITY_UNIT 56 Velocity unit on display
MAX_INTERNAL_TEMPERATURE 57 The maximum temperature that has been measured
inside the device during operation
MIN_INTERNAL_TEMPERATURE 58 The minimum temperature that has been measured
inside the device during operation
OPERATION TIME 59 The total number of hours the device has been in
operation
ENV_ENVIRONMENT 60 Process Condition
ENV_PRESENTATION 61 Tank Presentation
ENV_DEVICE_MODE 62 Service mode
ENV_WRITE_PROTECT 63 Write protect
DIAGN_DEVICE_ALERT 64 Errors, Warnings, Status, Plant web alerts
DIAGN_VERSION 65 Gauge SW version
DIAGN_REVISION 66 P1451 revision
DIAGN_DEVICE_ID 67 Device ID for the gauge.
Reference Manual Level Transducer Block
00809-0100-4530 April 2019
Reference Manual 429
To Next Page
Loading...
