Emerson Rosemount 5300 Series - Page 430

Table F-2: Level Transducer Block Parameters and Descriptions (continued)
Parameter Index Number Description
DIAGN_DEVICE_MODEL 68 Type of 5300. LF or HF
STATS_ATTEMPTS 69 The total number of messages sent to the transducer
A/D board
STATS_FAILURES 70 The total number of failed A/D board message
attempts
STATS_TIMEOUTS 71 The total number of timed out A/D board message
attempts
MAX_UPPER_PRODUCT_THICK-
NESS
72 This is the maximum thickness of the upper product
that the device is able to measure through. If the
thickness of the upper product is larger than this value,
the device will not be able to locate the interface echo
MEAS_STATUS 73
INTERFACE_STATUS 74
REMOTE_HOUSING 75
MEAS_VAPOR_DC 76 Measured Vapor Dielectric Constant
SPEC_CONFIG_TNZ 77 Configure Trim Near Zone
SPEC_CONFIG_PEP 78 Configure Probe End Projection
SPEC_CONFIG_TANK_MATERIAL 79 Configure Tank Material
SPEC_CONFIG_VC 80 Configure Vapor Compensation
VC_WARNING 81 Vapor Compensation Warning
PEP_STATUS 82 Probe End Projection Status
TANK_MATERIAL 83
SW_SUPPORT2 84 Defines what options are enabled in the device.
MOUNTING_TYPE 85
PIPE_DIAMETER 86
NOZZLE_HEIGHT 87
DEVICE_HW_CONFIG 88
DEVICE_STATUS 89
VOLUME_STATUS 90
MWM_WARNING 91
MEAS_WARNING 92
CONFIG_WARNING 93
VAPOR_COMP_STATUS 94 Vapor Compensation Status
Level Transducer Block Reference Manual
April 2019 00809-0100-4530
430 Rosemount 5300 Level Transmitter