EasyManua.ls Logo

Emerson Rosemount 5300 Series - Page 449

Emerson Rosemount 5300 Series
488 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Table I-1: Resource Transducer Block Parameters (continued)
Parameter Index number Description
RESTART 16 Allows a manual restart to be initiated. Several degrees of restart are
possible. They are the following:
1 Run – nominal state when not restarting
2 Restart resource – not used
3 Restart with defaults – set parameters to default values. See
START_WITH_DEFAULTS below for which parameters are set.
4 Restart processor – does a warm start of CPU.
RS_STATE 07 State of the function block application state machine.
SAVE_CONFIG_BLOCKS 62 Number of EEPROM blocks that have been modified since last burn.
This value will count down to zero when the configuration is saved.
SAVE_CONFIG_NOW 61 Allows the user to optionally save all non-volatile information
immediately.
SECURITY_IO 65 Status of security switch.
SELF_TEST 59 Instructs resource block to perform self-test. Tests are device specific.
SET_FSTATE 29 Allows the FAIL_SAFE condition to be manually initiated by selecting
Set.
SHED_RCAS 26 Time duration at which to give up on computer writes to function
block RCas locations. Shed from RCas shall never happen when
SHED_ROUT = 0
SHED_ROUT 27 Time duration at which to give up on computer writes to function
block ROut locations. Shed from ROut shall never happen when
SHED_ROUT = 0
SIMULATE_IO 64 Status of simulate switch.
SIMULATE_STATE 66 The state of the simulate switch:
0 = Uninitialized
1 = Switch off, simulation not allowed
2 = Switch on, simulation not allowed (need to cycle jumper/
switch)
3 = Switch on, simulation allowed
ST_REV 01 The revision level of the static data associated with the function block.
START_WITH_DEFAULTS 63 0 = Uninitialized
1 = do not power-up with NV defaults
2 = power-up with default node address
3 = power-up with default pd_tag and node address
4 = power-up with default data for the entire communications
stack (no application data)
STRATEGY 03 The strategy field can be used to identify grouping of blocks.
SUMMARY_STATUS 56 An enumerated value of repair analysis.
Reference Manual Resource Transducer Block
00809-0100-4530 April 2019
Reference Manual 449

Table of Contents

Other manuals for Emerson Rosemount 5300 Series

Related product manuals