Emerson ROSEMOUNT 5300 - Appendix B Product Certifications

Reference Manual
00809-0100-4530, Rev BA
July 2009
Rosemount 5300 Series
www.rosemount.com
Appendix B Product Certifications
Safety messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page B-1
EU Conformity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page B-2
European ATEX Directive Information . . . . . . . . . . . . . . . page B-3
NEPSI Approvals . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page B-8
Factory Mutual (FM) Approvals . . . . . . . . . . . . . . . . . . . . . page B-11
Canadian Standards Association (CSA) Approval . . . . .page B-14
IECEx Approval . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page B-17
Combination Approvals . . . . . . . . . . . . . . . . . . . . . . . . . . . page B-22
Approval Drawings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page B-22
SAFETY MESSAGES Procedures and instructions in this section may require special precautions to
ensure the safety of the personnel performing the operations. Information that
raises potential safety issues is indicated by a warning symbol ( ). Please
refer to the following safety messages before performing an operation
preceded by this symbol.
Explosions could result in death or serious injury:
Verify that the operating environment of the transmitter is consistent with the appropriate
hazardous locations certifications.
Before connecting a HART-based communicator in an explosive atmosphere, make
sure the instruments in the loop are installed in accordance with intrinsically safe or
non-incendive field wiring practices.
Do not remove the transmitter cover in explosive atmospheres when the circuit is alive.