Reference Manual
00809-0100-4530, Rev BA
July 2009
5-27
Rosemount 5300 Series
Device Specific
Configuration
11. Click the Device specific setup button
12. This window will show if any additional configuration is needed. Proceed
to step 13 if no configuration is needed.
Trim Near Zone is described further in “Handling of Disturbances from
Nozzle” on page C-4.
Probe End Projection is described further in “Probe End Projection” on
page C-10.
Vapor Compensation is described further in “Dielectric Constant Settings” on
page C-14.
Choose the Tank Material if recommended.
To Next Page
Loading...
