Emerson Rosemount 644R - ATEX and IECEx Certifications

Reference Manual
00809-0100-4728, Rev HA
December 2002
Models 644H and 644R
3-4
Fast Key Sequence Table 3-1 lists the fast key sequences for common transmitter functions.
NOTE:
The fast key sequences assume that DD Dev v6, DD v1 is being used. Some
features apply only to the Model 644H, as noted in the following pages.
Table 3-1 provides alphabetical function lists for all Model 275 HART
Communicator tasks as well as their corresponding fast key sequences.
Table 3-1. Model 644 Fast Key Sequence
Function Fast Keys Function Fast Key
Active Calibrator 1, 2, 2, 1, 3 Num Req Preams 1, 3, 3, 3, 2
Alarm/Saturation 1, 3, 3, 2 Open Sensor Holdoff 1, 3, 5, 3
AO Alarm Type 1, 3, 3, 2, 1 Percent Range 1, 1, 5
Burst Mode 1, 3, 3, 3, 3 Poll Address 1, 3, 3, 3, 1
Burst Option 1, 3, 3, 3, 4 Process Temperature 1, 1
Calibration 1, 2, 2 Process Variables 1, 1
Callendar-Van Dusen 1, 3, 2, 1 PV Damping 1, 3, 3, 1, 3
Configuration 1, 3 PV Unit 1, 3, 3, 1, 4
D/A Trim 1, 2, 2, 2 Range Values 1, 3, 3, 1
Damping Values 1, 1, 10 Review 1, 4
Date 1, 3, 4, 2 Scaled D/A Trim 1, 2, 2, 3
Descriptor 1, 3, 4, 3 Sensor Connection 1, 3, 2, 1, 1
Device Info 1, 3, 4 Sensor 1 Setup 1, 3, 2, 1, 2
Device Output Configuration 1, 3, 3 Sensor Serial Number 1, 3, 2, 1, 4
Diagnostics and Service 1, 2 Sensor 1 Trim 1, 2, 2, 1
Filter 50/60 Hz 1, 3, 5, 1 Sensor 1 Trim-Factory 1, 2, 2, 1, 2
Hardware Rev 1, 4, 1 Sensor Type 1, 3, 2, 1, 1
Hart Output 1, 3, 3, 3 Software Revision 1, 4, 1
Intermittent Detect 1, 3, 5, 4 Status 1, 2, 1, 4
LCD Display Options 1, 3, 3, 4 Tag 1, 3, 4, 1
Loop Test 1, 2, 1, 1 Terminal Temperature 1, 3, 2, 2,
LRV (Lower Range Value) 1, 1, 6 Test Device 1, 2, 1
LSL (Lower Sensor Limit) 1, 1, 8 URV (Upper Range Value) 1, 1, 7
Measurement Filtering 1, 3, 5 USL (Upper Sensor Limit) 1, 1, 9
Message 1, 3, 4, 4 Variable Mapping 1, 3, 1
Meter Configuring 1, 3, 3, 4, 1 Variable Re-Map 1, 3, 1, 5
Meter Decimal Point 1, 3, 3, 4, 2 Write Protect 1, 2, 3
2-Wire Offset 1, 3, 2, 1, 2, 1