Emerson Rosemount 700XA - Safety and Operational Precautions; General Safety Guidelines

2. LIMITATION OF REMEDY AND LIABILITY: SELLER SHALL NOT BE LIABLE FOR
DAMAGES CAUSED BY DELAY IN PERFORMANCE. THE SOLE AND EXCLUSIVE
REMEDY FOR BREACH OF WARRANTY HEREUNDER SHALL BE LIMITED TO REPAIR,
CORRECTION, REPLACEMENT, OR REFUND OF PURCHASE PRICE UNDER THE LIMITED
WARRANTY CLAUSE IN SECTION 1 HEREIN. IN NO EVENT, REGARDLESS OF THE
FORM OF THE CLAIM OR CAUSE OF ACTION (WHETHER BASED IN CONTRACT,
INFRINGEMENT, NEGLIGENCE, STRICT LIABILITY, OTHER TORT, OR OTHERWISE),
SHALL SELLER'S LIABILITY TO BUYER AND/OR ITS CUSTOMERS EXCEED THE PRICE
TO BUYER OF THE SPECIFIC GOODS MANUFACTURED OR SERVICES PROVIDED BY
SELLER GIVING RISE TO THE CLAIM OR CAUSE OF ACTION. BUYER AGREES THAT IN
NO EVENT SHALL SELLER'S LIABILITY TO BUYER AND/OR ITS CUSTOMERS EXTEND
TO INCLUDE INCIDENTAL, CONSEQUENTIAL, OR PUNITIVE DAMAGES. THE TERM
“CONSEQUENTIAL DAMAGES” SHALL INCLUDE, BUT NOT BE LIMITED TO, LOSS OF
ANTICIPATED PROFITS, LOSS OF USE, LOSS OF REVENUE, AND COST OF CAPITAL.
Precautions and warnings
Note
The analyzer electronics and oven assembly, when housed inside a purged enclosure, meet
the certifications and classifications identified in the Specifications section of the this manual
(see Specifications) and in the Rosemount 700XA Product Data Sheet, which is located on the
Rosemount website (Emerson.com/Rosemount).
WARNING
SAFETY COMPLIANCE
The seller does not accept any responsibility for installations of the Rosemount 700XA Gas
Chromatograph (GC) or any attached equipment in which the installation or operation
thereof has been performed in a manner that is negligent and/or non-compliant with
applicable safety requirements.
Install and operate all equipment as designed and comply with all safety requirements.
If the unit is not operated in a manner recommended by the manufacturer, the overall
safety could be impaired.
WARNING
SUPPLY MAINS CONNECTION
The unit is intended to be connected to supply mains by qualified personnel in accordance
with local and national codes.
WARNING
EXPLOSION HAZARD
Do not open when energized or when an explosive atmosphere is present.
Keep cover tight while circuits are live.
Use cables or wires suitable for the marked "T" ratings.
Cover joints must be cleaned before replacing the cover.
Conduit runs to GC enclosure must have sealing fitting adjacent to enclosure.
November 2023 Quick Start Guide
Quick Start Guide 3