Emerson Rosemount 8600 Series - Product Certifications and Standards

Reference Manual
00809-0100-4860, Rev BF
Configuration
May 2019
8
Rosemount 8600 Vortex Flow Meter
Mass Flow Units
Note
If you select a Mass Units option, you must enter process density in your configuration. See
the Density/Density Ratio section on page 13.
Velocity flow
Allows the user to view the current velocity flow value and units. Also allows the user to
configure the velocity flow units.
Velocity flow
Displays the current velocity flow value and units.
Velocity units
Allows the user to select the velocity units from the available list
 ft/s
 m/s
Velocity measured base
Determines if the velocity measurement is based on the mating pipe ID or the meter body
ID.
Totalizer
Tallies the total amount of liquid or gas that has passed through the flowmeter since the
totalizer was last reset. It enables you to change the settings of the totalizer.
lb/s STon/min
lb/min STon/h
lb/h STon/d
lb/d MetTon/mi
n
kg/s MetTon/h
kg/min MetTon/d
kg/h g/s
kg/d g/min
g/h
FastKeys
1, 1, 4, 3
FastKeys
1, 1, 4, 3, 1
FastKeys
1, 1, 4, 3, 2
FastKeys
1, 1, 4, 3, 3
FastKeys
1, 1, 4, 4