Emerson Rosemount 8600 Series - Page 17

9
Rosemount 8600 Vortex Flow Meter
Reference Manual
May 2019
Configuration
00809-0100-4860, Rev BF
Total
Provides the output reading of the totalizer. Its value is the amount of liquid or gas that has
passed through the flowmeter since the totalizer was last reset.
Start
Starts the totalizer counting from its current value.
Stop
Interrupts the totalizer count until it is restarted again. This feature is often used during
pipe cleaning or other maintenance operations.
Reset
Returns the totalizer value to zero. If the totalizer was running, it will continue to run
starting at zero.
Totalizer config
Used to configure the flow parameter (volume, mass, velocity) that will be totalled.
Note
The totalizer value is saved in the non-volatile memory of the electronics every three
seconds. Should power to the transmitter be interrupted, the totalizer value will start at the
last saved value when the power is re-applied.
Note
Changes that affect the density, density ratio, or compensated K-Factor will affect the
totalizer value being calculated. These changes will not cause the existing totalizer value to
be recalculated.
Pulse frequency
Allows users to view the pulse output frequency value. To configure the pulse output, refer
to the section on pulse output found on page 52.
Vortex frequency
Allows users to view the shedding frequency directly off of the sensor.
FastKeys
1, 1, 4, 4, 1
FastKeys
1, 1, 4, 4, 2
FastKeys
1, 1, 4, 4, 3
FastKeys
1, 1, 4, 4, 4
FastKeys
1, 1, 4, 4, 5
FastKeys
1, 1, 4, 5
FastKeys
1, 1, 4, 6