Figure 12-3: Sensor adapter direct lead pins
A
18
17
19
3
2
1
B
A. Electrode side
B. Coil side
12.6.3
Socket module
Figure 12-4: Remote Mount Socket Module
12.7 Installed sensor tests
If a problem with an installed sensor is identified, refer to Table 12-8 through Table 12-12
to assist in troubleshooting the sensor. Disconnect or turn off power to the transmitter
before performing any of the sensor tests. Always check the operation of test equipment
before each test.
If possible, take all readings from the preferred locations identified in Sensor adapter feed
through pins, Sensor adapter direct lead pins, and Socket module. If the recommended
Troubleshooting Reference Manual
November 2019 00809-0100-8782
142 Rosemount
®
8782 Slurry Magnetic Flow Meter Transmitter with HART Protocol
To Next Page
Loading...
