Emerson Rosemount 8782 - Local Operator Interface (LOI); Other Configuration Tools; Measurement Units

Auto zero
The Auto zero is recommended for optimum performance when a flow meter is initially
installed, and it typically does not need to be performed again. However, if process
conditions drastically change, a new Auto zero is recommended. The sensor must be filled
completely with process fluid at zero flow. For more information, see Auto zero.
5.2 Local operator interface (LOI)
To access the transmitter menu, press the XMTR MENU key. Use the UP, DOWN, LEFT(E),
and RIGHT arrows to navigate the menu structure.
A complete map of the LOI menu structure is shown in LOI Menu trees.
The display can be locked to prevent unintentional configuration changes. The display lock
can be activated through a HART communication device, or by holding the UP arrow for
three seconds and then following the on-screen instructions.
5.3 Other configuration tools
Table 5-1 shows the approximate category or location of basic setup parameters for
typical configuration tools.
Table 5-1: Approximate setup category/locations for typical configuration tools
Function Category/Location
Flow Units
Basic Setup
PV Upper Range Value (URV) Basic Setup → AO
PV Lower Range Value (LRV) Basic Setup → AO
Auto zero
Diagnostics
Calibration Number Basic Setup → Setup
Line Size Basic Setup → Setup
Tag Device Info → Identification
Long Tag Device Info → Identification
5.4 Measurement units
Table 5-2: Volumetric flow units
gal/sec gal/min gal/hr gal/day
L/sec L/min L/hr L/day
ft3/sec ft3/min ft3/hr ft3/day
cm3/min
m3/sec m3/min m3/hr m3/day
Basic Configuration Reference Manual
November 2019 00809-0100-8782
42 Rosemount
®
8782 Slurry Magnetic Flow Meter Transmitter with HART Protocol