Emerson Rosemount 8782 - Page 62

Totalizer
Control
The totalizer control buttons enable you to view, start, stop, read, and
reset the totalizer.
—VIEW TOTAL. Scroll through the totalizer values in aphabetical
order (Totalizer A, Totalizer B, Totalizer C).
—START/READ. This functionality applies to the currently displayed
totalizer value.
• If the totalizers are not running, pressing this button starts ALL
totalizers counting.
• If the totalizers are running, pressing this button pauses the display,
enabling the user to read the total value. It does NOT stop the
totalizer value from accumulating in the background. Pressing the
button while the display is paused returns the display to the
accumulating totalizer value
—STOP/RESET. This functionality applies to the currently displayed
totalizer value.
• If the totalizers are running, pressing this button stops ALL totalizers
from accumulating.
• If the totalizer is stopped, pressing this button resets the total value to
a value of zero.
Note
If you attempt to reset the totalizer from the LOI when it is configured
as non-resetable from the LOI, a notification appears.
Diagnostics
The diagnostics buttons provide direct access to the advanced diagnostic
functions of the transmitter and meter verification.
—ADV DIAG. Access the advanced diagnostic menu.
—METER VERIFY. Run Meter Verification.
Basic Config
The basic config buttons provide direct access to the most common
transmitter parameters.
—SENSOR CAL NO. Access the sensor calibration number
parameter. Press , , and to modify the sensor calibration number.
Press to store the new value as the sensor calibration number.
—SENSOR SIZE. Access the Line Size parameter. Press or to
select the sensor line size. Press to increment the line size. Press to
store the new value as the sensor line size.
Operation Reference Manual
November 2019 00809-0100-8782
62 Rosemount
®
8782 Slurry Magnetic Flow Meter Transmitter with HART Protocol