36
Reference Manual
00809-0100-4772, Rev FA
Installation
March 2016
Installation
Figure 3-15. Remote Electronics Installation
3.5.8 Calibration
The flowmeters are wet-calibrated at the factory and need no further calibration during
installation. The calibration factor (K-factor) is stamped on each meter body and is entered
into the electronics.
3.6 Electronics considerations
Both integral and remote mounted electronics require input power at the electronics. For
remote mount installations, mount the electronics against a flat surface or on a pipe that is
up to two inches in diameter.
Remote mounting hardware includes an L bracket that is stainless steel and one stainless
steel u-bolt. See Figure 3-15 on page 36 for dimensional information.
A. Meter body
B. Support tube
C. Sensor cable nut
D. Nut
E. Washer
F. Union
G. Meter adapter
H. Coaxial cable
I. ½ NPT conduit adapter or cable gland (supplied by customer)
J. Electronics housing
K. Coaxial cable nut
L. Housing adapter screws
M. Housing adapter
N. Housing base screw
O. Ground connection
To Next Page
Loading...
