44
Reference Manual
00809-0100-4772, Rev FA
Transducer Block
March 2016
Transducer Block
1. K Factor
2. Service Type
3. Pipe Inside Diameter
4. Pipe Inside Diameter Units
5. Damping
6. Flange Type
7. Wetted Material
8. Meter Body Number
9. Process Temperature
10. Process Temperature Units
11. Filter Auto Adjust (to approximate process fluid density)
12. Meter Display. (If optional local display is installed.)
13. AI Block - Channel. Set to Flow.
14. AI Block - XD_SCALE.UNITS_INDEX. Select engineering units for flow.
15. AI Block - L_TYPE. Usually set to Direct.
If mass flow engineering units are selected (lb/sec, kg/sec, etc.) then you must configure:
1. Process Density
2. Process Density Units
To Next Page
Loading...
