2. Install and tighten the eductor (G) in the eductor holder (O).
3. Install and tighten the elbow (N) on the eductor (G).
The male port of the elbow must point up and be in line with the long axis of
eductor.
4. Apply anti-seize component to the external pipe threads of eductor holder (O).
5. Install and tighten eductor holder (O) in sensor housing (P). Align eductor with
matchmark, as shown in Figure 9-16.
Eductor alignment matchmarksFigure 9-16:
A. Eductor flat
B. Straight edge
C. Matchmark
Maintenance and service
238 OCX 8800
To Next Page
Loading...
